When you do the laser focus calibration, either initially, or going to the menu and doing it (the one where you set the end of the laser on the bed), it sets Z0. I have to guess at the height of the laser module from the surface of the material. However I have two issues when trying to engrave there is no place to enter material thickness and when ready to engrave unlike Luban there is not the automatic material thickness via camra feature. It then lets you use the machine’s auto leveling feature to automatically select the correct height.ĭo make sure that you don’t have Z-offsets set in your cuts, since the machine should already be at the correct Z height when starting the job.Īlso, this will run the job dependent on the set origin, you can change it after the leveling process and you should be able to run boundary (although, it’s not as good as LB’s rubberband feature).
0 kommentar(er)
